Connector 8-pole / 8-way
This cord, cable or welding clamp is a simple and fast way to connect multiple lamps without screws. Think for example of connecting multiple (installation) wires in a ceiling cap. Unlike a traditional splice clamp, this clamp is resealable. By putting the tabs up, the wires can easily be disconnected again, allowing you to use the clamp more often.
This clamp is suitable for connecting up to 8 wires (or 7 lamps) to each other (in 1 clamp). Are you connecting fewer lamps? Then you can leave a channel empty. Smaller 2-pole, 3-pole and 5-pole clamps are also available.
How to use?
Strip the wire to a sufficient distance of approx. 9-10 mm (you can also measure it from the bottom of the clamp, see photo) and insert it into the clamp. There, the wire makes contact with the other clamped wires and a connection is created between them.
Make sure that you use a separate terminal for each colour of wire. Never connect different colours to the same wire terminal.
The clamp can clamp both flexible and rigid wires. Suitable for conductors with a diameter of 0.08 to 2.5 mm².
✓ Easy to use
✓ Substitute for terminal block
✓ Suitable for 8 installation wires
✓ Suitable for minimum 0,08 and maximum 2,5mm² wires
✓ Can also be used as a welding cap (to cap power wires)
✓ Suitable for flexible and rigid conductors
✓ Suitable for 12V, 24V and 230V