Cord Dimmer - universal - with push button 0-50W | White
✓ Smooth dimming
✓ Dimming range 0-100%
✓ Memory function
✓ Suitable for LED lamps 0-50W
✓ Suitable for halogen lamps 10-100W
This white universal cord dimmer has a length of 96,8 mm, height of 30,4 mm and has a width of 24,9 mm. The cord dimmer features a push button with which you can dim your LED lamps. With the dimming range of 0-50W, you can dim up to a maximum of 50W of LED lamps.
Voltage: 220-240V 50Hz
Dimming method: R,C Trailing Edge
Dimming style: Push button
Ambient temperature: max. 35° C
Weight: 36.9 gram
Installation instructions (Download the manual or the datasheet for this dimmer)
1. Make sure that there is no voltage on the cord to be connected when mounting!
2. Open the housing by loosening and removing the screws C (these are under the rubber feet)
3. Remove button A and cover B
4. Loosen the screws of the strain relief D
5. Clear the wire ends (approx. 5 mm)
6. Connect the veins of the feeding cord (where the plug is attached) to points L and N
7. Connect the cord to the lamp to OUT connections on the circuit board
8. Secure the cord with the strain relief D
9. Replace housing B and button A
10. Fasten the housing using the screws C
11. If the red light is on, the dimmer has power.
12. Briefly press the button to switch on (takes a short while due to memory function). Hold the button down to make the lamp brighter. Hold the button again to get less bright. For switch-off, briefly press the button.
Setting minimum and maximum brightness
1. Turn on the lights by pressing the button and turn the knob to the minimum brightness
2. Insert the screwdriver into the MIN screw and turn it to the left
3. If the light becomes unstable (flashes), turn the screwdriver to the right until the blinking stops
4. Now turn the knob to maximum brightness and insert the screwdriver into the MAX screw and turn it to the right
5. If the light becomes unstable (flashes), turn the screwdriver to the left until the blinking stops